13 UNIT START UP
Turn on hot and cold water supply valves.
CAUTION: Check all connections for leaks. Failure to do so can result in
water damage.
14
14A
14 FLUSHING
To prevent damage to the internal parts of your faucet from debris that may have collected
in the water lines, it is necessary to flush the system. Open Valves (14A) to full on position
and activate Diverter Valve by lifting Knob (14B) allowing water to flow from the Spray
Hose (14C). Run water for one minute. Repeat in hot and cold positions.
15
16 HAND HELD SHOWER INSTALLATION
Insert Washer (15A) into Metal Hose Fitting (15B) located on the end of Decorative
Hose (15C). Connect Hand Held Shower (15D) into the end of Decorative Hose (15C)
by turning Metal Hose Fitting (15B) clockwise. Hand tighten.
14B
14A
14C
15D
15A
15B
15C
ENGLISH
16
1
5
/
"
4
(133 mm)
17 AIR GAP
Air Gap for this spout is as shown. Please consult your local building code for Air Gap
restrictions.
MAINTENANCE & CARE
CAUTION: Maintenance
DISASSEMBLY
1.
Replacement parts may be available at the store where you purchased
your faucet.
2.
When replacement parts are not available, please write or call Price
Pfister Consumer Service.
3.
Always turn off water and relieve pressure before working on your
faucet.
NOTE: Trim Care
Cleaning Instructions:
For all handles and decorative finishes, use only a soft damp
cloth to clean and shine. Use of polish, detergents, abrasive
cleaners, organic solvents or acid may cause damage. Use of
other than a soft damp cloth will nullify our warranty!
Special Trim:
Trim products which contain porcelain or other similar substance
are not acceptable for public areas or commercial use. Installation
of Said Trim is at Users Risk!
1–800–PFAUCET (1–800–732–8238)
For Toll-Free Pfaucet information call
1–800–PFAUCET (1–800–732–8238)
or visit www.pricepfister.com
• Installation Support
• Care and Warranty Information
5