12
12A
CLOSED
12 VALVE FUNCTION
By rotating the Lever Handle (12A) slightly counterclockwise, the valve will be
fully activated to the "COLD" position. The water temperature can be increased
by continuing to rotate the Lever Handle (12A) in a counterclockwise direction.
13
UP
For
Shower
13B
13 TUB SPOUT FUNCTION
When the valve is turned on, water normally flows through the Tub Spout (13A).
To activate the shower, turn valve on and pull the Knob (13B) up. Hold on until
water flows continuously from the shower arm.
14
14C
14B
14 FINAL FLUSHING
For final flushing, turn valve on and allow water to run through the Tub Spout
(14A) for several minutes. Pull Spout Knob (14B) up to allow water to run
through Shower Arm (14C). Allow water to run for several minutes until all foreign
matter clears the line.
FULL HOT
OPEN
FULL COLD
13A
14A
ENGLISH
15
15A
A
15 SHOWER HEAD FUNCTION
A. To adjust spray, turn Outer Shell (15A) to a desired spray pattern.
B. To adjust spray, turn Knob (15B) to a desired spray intensity.
16
16A
16 SHOWER HEAD INSTALLATION
Thread Shower Head (16A) onto Shower Arm (16B).
MAINTENANCE & CARE
.
CAUTION: Maintenance
DISASSEMBLY
1.
Replacement parts may be available at the store where you
purchased your faucet.
2.
When replacement parts are not available, please write or
call Price Pfister Consumer Service.
3.
Always turn off water and relieve pressure before
working on your faucet.
NOTE: Trim Care
Cleaning Instructions:
For all handles and decorative finishes, use only a soft damp
cloth to clean and shine. Use of polish, detergents, abrasive
cleaners, organic solvents or acid may cause damage. Use of
other than a soft damp cloth will nullify our warranty!
Special Trim:
Trim products which contain porcelain or other similar
substance are not acceptable for public areas or commercial
use. Installation of said trim is at user's risk!
4
B
16B
15B