24
24 UNIT START UP
Turn on hot and cold water supplies, and check for leaks above and below
the sink.
MAINTENANCE & CARE
25
25A
25E
25D
25C
25 FLUSHING & AERATOR CLEANING
After installation is complete, remove Aerator Housing (25A). Turn Valves
(25B) on and allow both hot and cold water to run for at least one minute each.
While water is running, check for leaks. To clean the aerator, disassemble Aerator
Housing (25A) by separating the Aerator Shell (25C), Basket (25D), and Washer
(25E). Once parts have been cleaned, reassemble by reversing steps.
26
26B
26A
26 VALVE CARTRIDGE MAINTENANCE
Turn off water supplies and relieve pressure before working on your faucet
(see step 2). Remove Handles (26A) (see step 14), Flange Fittings (26B)
(see step 12). Unscrew Cartridge Assembly (26C) and inspect. Replace parts
as necessary.
ENGLISH
25B
26C
8
27
27B
27C
27D
27A
27G
27F
27 HOSE CONNECTION REMOVAL
To detach Hose Assembly (27A), remove Clips (27B) from End Bodies (27C)
and pull the End Connectors (27D) from End Bodies (27C). Remove Center
Connector (27E) by pushing up on the Quick Connect Housing (27F), holding
gray plastic Collet (27G) in place, and pulling down on Quick Connect Housing
(27F) until Tube ( 27H) is free.
CAUTION: Maintenance
DISASSEMBLY
1.
Replacement parts may be available at the store where you purchased
your faucet.
2.
When replacement parts are not available, please write or call Price
Pfi ster Consumer Service.
3.
Always turn off water and relieve pressure before working on your
faucet.
NOTE: Trim Care
Cleaning Instructions:
For all handles and decorative fi nishes, use only a soft damp cloth to clean
and shine. Use of polish, detergents, abrasive cleaners, organic solvents, or
acid may cause damage. Use of other than a soft damp cloth will nullify
our warranty!
Special Trim:
Trim products which contain porcelain or other similar substances are not
acceptable for public areas or commercial use. Installation of said trim is at
user's risk!
27E
27C
27D
27H
27F
27B