4.
Replace the fuse with one of the same sizes and rating only.
The 120 Vac and 240 Vac units use a 1 ampere, 250 volt, slow blow GMC fuse (Little-
fuse Part No. 0313001-HXP or equal).
5.
Reassemble the unit by threading the glass dome assembly into the
main housing until tight.
C.
Cleaning the Enclosure
Maintenance procedures sometime require fixtures to be hosed down
for good housekeeping. The circuit must be turned OFF and the
dome MUST be allowed to cool to ambient room temperature before
cleaning.
The fixture should be cleaned periodically to maintain maximum light output.
Only mild, non-abrasive cleaning agents should be used. The glass dome should be
regularly inspected for scratches and chips, and if damaged, must be replaced.
D.
Lubrication
The threaded joint on the pendant mount should be kept well lubricated
with a corrosion-inhibiting grease such as petrolatum or soap-thickened mineral oils.
If corrosive products have accumulated on explosion-proof joints and cannot readily be
removed with solvents, the parts should be discarded and replaced.
EXPLOSION HAZARD — Never use an abrasive material or file to
remove corrosive products from threaded surfaces. In extremely
corrosive locations, equipment should be periodically inspected to
guard against unusual deterioration and possible porosity, since this
may weaken the enclosure structurally.
E.
Service
Federal Signal will service your equipment and provide technical assistance
with any problems that cannot be handled locally by Federal Signal's Distributor or
Manufacturer Representative.
If any unit returned to Federal Signal for service, inspection, or repair must
be accompanied by a Return Material Authorization number with a brief explanation
of the service being requested and/or the nature of the malfunction. This R.M.A. can be
obtained from the local Federal Signal Distributor or Manufacturer's Representative.
Address all communications and shipments to:
FEDERAL SIGNAL CORPORATION
Industrial Products Division
2645 Federal Signal Drive
University Park, IL 60484-3167
Phone: +1 877 289 3246
Fax: +1 708 534 4887
www.federalsignal-indust.com
NOTE
+1 708-534-4756
•
-6-