Kalorik PPG 45587 Manual De Instrucciones página 8

• To close the battery housing, put the battery cradle back into the
appliance, and replace the cap turning it clockwise until it gets
locked firmly.
Important:
• Do not mix old and new batteries
• Do not mix alkaline, standard (carbon-zinc), or rechargeable (ni-
cad, Ni-MH, etc.) batteries
If your appliance does not work properly, it is probably because the
batteries are discharged. In that case, recharge the batteries on the
charging base, or replace the batteries with a new set of NiMH
rechargeable batteries.
This product includes four Ni-Mh rechargeable and recyclable batteries
(1.2V) in each mill. At the end of the batteries' useful life, they should be
recycled. These batteries must not be incinerated or composted. See
"Protection of the environment". Do not incinerate or compost
batteries, as they will explode at high temperatures.
TROUBLESHOOTING
If the mill does not grind, or if no motor noise can be heard, please
check that the batteries are installed correctly and are not discharged.
If the mill gets stuck during use (motor produces hum, but internal shaft
does not turn and no pepper is ground], gently shake the mill or tap the
mill gently on a hard surface, to remove the stuck pepper or salt.
To remove deeply stuck peppercorn, remove the upper lid as if for re-
filling the mill, turn the coarseness setting to its coarsest, and tap lightly
on a hard surface until all the peppercorn is released. Re-adjust
coarseness setting to the desired level once done and replace upper
lid.
Note: Too fine a grind setting may not enable salt or pepper to be
ground. If this is the case, set the grinder to a coarser setting (see
above).
www.KALORIK.com
8
PPG 45587 - 180330