Filling, Check Of The Filling Level And Draining The Solution Tank; Filling Of The Solution Water Tank; Display Of The Filling Level Of The Solution Water Tank; Draining Of The Solution Water Tank - LAVOR Pro SPEED 45E Manual Del Usaurio

7.9 FILLING, CHECK OF THE FILLING LEVEL
AND DRAINING THE SOLUTION TANK
☞
( ) The temperature of the water or the de-
tergent should never exceed 50°C.
☞
( ) At every filling of the solution tank (Photo 1 -
D), always remember to empty the recovery tank
(Photo 3 - C) (see 7.10).
7.9.1 FILLING OF THE SOLUTION WATER
TANK
!
( ) The filling of the solution water tank
should NOT be done with the machine in the
raised position.
- Pour into the tank the required quantity of the
chemical product, considering the percentage indi-
cated by the supplier, with reference to the full tank
capacity listed on the product sheet.
!
( ) Use only those products suitable for the floor
and the dirt to be removed.
- Pour water in the filling opening placed in the
front of the machine ( Photo 27 - A ).
Leave 2 cm between the filling opening and the liq-
uid level. Do not fill beyond this point!
A
Photo 27
A) Solution tank filling opening with filter
B) Closing cap

( ) The machine have been designed for the
use with non-foaming and biodegradable de-
tergents made specifically for scrubber-dri-
ers. The use of other chemical products (such
as sodium hypochlorite, oxidizers, solvents
or hydrocarbons) may damage or destroy the
machine.
- Follow the safety regulations specified in the rel-
ative section and indicated on the detergent con-
tainer.
- Contact the machine manufacturer to obtain a
complete list of available and suitable detergents.
☞
( ) Always use non-foaming and biodegrad-
7 - OPERATING INFORMATIONS
able detergents
- Do not leave the water hose unattended and in-
sert it completely into the tank: the hose might
move and get sensitive parts of the machine wet.
- Close the tank with its plug.
7.9.2 DISPLAY OF THE FILLING LEVEL OF
THE SOLUTION WATER TANK
The filling level of the solution water tank can be
viewed through the transparent hose at the rear of
the machine (Photo 28 - A).
A) Drain hose of the solution tank with
level display
B) Plug of the drain hose
7.9.3 DRAINING OF THE SOLUTION WATER
TANK
The emptying of the solution water tank can be
made through the transparent hose on the back
of the machine (Photo 28 - A).
- Disconnect the hose from its holder and place it
next to a container or a sewer drain.
- Remove the cap of the hose (Photo 28 - B) and
wait for the complete emptying of the tank.
- After the draining, close the hose with the cap
and place it in its slot.
43
B
A
Photo 28