Cleaning And Maintenance - Stanley ST-22-240-E Manual De Instrucciones

NEVER LEAVE HEATER UNATTENDED WHILE
Operation
1. Position the fan heater so that it stands
upright on a firm, level surface and at
a safe distance from wet environments
and flammable objects.
2. Connect the fan heater to the proper
electrical power.
3. Set the thermostat dial to "+".
4. The fan heater will switch on when the
function selector dial is set to one of the
power settings.
5. Once the room reaches the desired
temperature, turn the thermostat dial
back until heating element turns off.
6. Before you switch off the heater, please
turn the thermostat to "-" and turn
the switch to the fan position. Let the
appliance cool down for two minutes,
and only then turn off the heater and
pull out the plug from the power supply.
Automatic Overheat Safety Control
- This heater is equipped with safety
internal heat limiting thermostat and
overheat protection circuit. When a
potential overheat temperature is
reached, the system will automatically
shut the heater off.
Thermostat Instructions
- At first, set the thermostat to "+" and let
the heater operate with full power input.
When the room temperature reaches
the required value, turn the thermostat
to the left until it switches off.
© 2018, Obelis S.A Registered Address:
Bd. Général Wahis, 53 1030 Brussels, Belgium
CONNECTED TO A POWER SOURCE
- The thermostat will then switch on and
off automatically to control the room
temperature according to the preset
value and keep the room temperature
constant.
- When using the heater for the first time,
you may notice a slight emission of
smoke. This is quite normal and it stops
after a short time. The heating element
is made of steel and was coated with a
layer of protective oil during production.
The smoke is caused by the leftover oil
as it is heated.

Cleaning and Maintenance

- Before cleaning the appliance,
disconnect it from the outlet and let it
cool down.
- The enclosure is easy to get dirty. Wipe
it often with a soft sponge. For very
dirty parts, wipe with a sponge dipped
in < 50°C water and mild detergent,
then dry the heater enclosure with a
clean cloth. Be careful not to let the
water enter the inside of the appliance
- In order to protect the enclosure, don't
splash water onto the heater, and never
use a solvent like gasoline, isoamyl
acetate, toluene, etc. to clean the
heater.
- When you store the heater, let it cool
down first and, keep it dry. Then cover
it with a plastic bag, put it in the packing
box and store it in a dry, ventilated
place.
8