Medela Basic 30 Instrucciones De Uso página 7

Safety instructions
– The Medela Basic 30 is a medical device that requires special safety measures in regard to
EMC. It must be installed and put into operation in accordance with the attached EMC infor-
mation.
– In the case of overflow, inform the internal technical service immediately and perform the
tasks in the service manual.
– In each of the following cases, the device must not be used and it must be repaired by
Customer Services:
– if the power cord or the plug are damaged
– if the device is not functioning perfectly
– if the device is damaged
– if the device shows clear safety defects.
– Keep the power supply cord away from hot surfaces.
– The mains plug and the on / off switch must not come into contact with moisture.
– Never pull the mains plug out of the fixed mains socket by pulling on the power supply cord!
– Never leave the device unattended when it is switched on.
– The pump must stand upright during use.
– Never use the device at high room temperatures, while bathing or showering, if you are very
tired or in an environment where there is a risk of explosion.
– Never place the device in water or other liquids.
– When using single use, sterile products, please note that they are not intended to be repro-
cessed. Reprocessing could cause loss of mechanical, chemical and / or biological character-
istics. Reuse could cause cross contamination.
– Contact your local Medela customer service representative for assistance with product oper-
ations.
These instructions for use must be kept for later reference.
Warnings & Safety instructions
| 7