Mosa MAGIC WELD Manual Del Usuario página 47

© MOSA REV.0-05/04
check daily
NOTE
Do not alter the primary conditions of
regulation and do not touch the sealed parts.
1. Turn the fuel cock (87) to ON.
RUBINETTO COMBUSTIBILE
2. Switch the choke control (66) to CLOSE
N.B.: Do not use the air valve if the motor is
hot or the air temperature is too high.
CLOSE
3. Turn the engine switch (28) to the ON position
ENGINE SWITCH
Engine starting
CHOKE LEVER
CLOSE
Lightly pull the start-up knob (73) until meeting
resistance, then pull decisively.
ATTENTION:
Allow the start-up knob to re-enter slowly,
avoiding having it knock against the motor and
thereby damaging the start-up system.
STARTER GRIP
4.When the engine is started the machine
reaches maximum engine speed immediately
(4000 rpm) for 6/7 seconds, after which the
engine speed automatically decreases to
minimum (2000 rpm). The minimum is set by
the solenoid which acts on the accelerator
lever.
5.The engine reaches maximum speed only
when current is drawn in welding or auxiliary
power mode.
M
MAGIC WELD 26