Publicidad
GE Rigid Light Bar
Electric drill
Clean the mounting surface.
This device complies with part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may
cause undesired operation.
CAN ICES-005 (A) / NMB-005 (A)
Note: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.
24V LED Power supply
Model list:
Peel off the release paper from the back
Connect the SA2-01 connector.
SA2-01 connector
Rated
Input
Model number
power
Voltage(V)
(W)
6.3
GERLB2465-1120-1
3.1
24VDC
GERLB2465-0560-1
3.1
GERLB2465-0240-1
Connect the main line of rigid bar to
the 24V power supply.
M3 self-tapping screw
Power supply rating:
Input: 100V-240V, 50Hz/60Hz
Output: 24V DC, 6.3 A
Distribute the rigid bars in the light
box according to proper spacing. Be
careful not to damage lens, LEDs
and electronic components of the
rigid bar.
If the bar need to be jointed, please
arrange it as the picture shows.
2
Publicidad
