Fan Assembly. Pgs - Craftmade Targas TG52 Guia De Instalacion

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

5. Fan Assembly.
Remove 6 screws and washers from yoke plate
(located on top plate on top of motor housing)
and set aside. Lift yoke plate and top plate to
remove from motor housing and set aside.
Time Saver: Washers can be set on each blade
plate screw prior to installing blades.
Locate 9 decorative blade plate attachment
screws and washers in one of the hardware
packs. Hold blade plate up to blade, aligning
posts in blade plate with holes in blade as
shown in diagram. Insert 3 blade plate
attachment screws (along with washers) with
fingers first and then tighten screws securely
with a Phillips screwdriver. Repeat for the
remaining blade plates.
Locate 9 blade attachment screws/washers in
hardware pack. Slide blade through one of the
narrow, rectangular openings on center band,
aligning holes in blade with holes in blade arm
(located inside motor housing). Insert 3 blade
attachment screws/washers with fingers first
and then tighten screws securely with a Phillips
screwdriver. Repeat procedure for each
remaining blade.
Re-attach top plate and yoke plate to yoke
using washers and screws previously removed.
Be sure that semicircular cutout on top plate and
yoke plate aligns over yoke set screws for a proper
fit. (Also make sure that reverse switch aligns
properly with hole for reverse switch in top
plate--see drawing.) Tighten screws to secure
top plate and yoke plate.
["Fan Assembly" continued on next page.]
blade plate attachment
screws and washers
yoke
blade
arms
page 4
blade
yoke plate
hole for reverse switch
top plate
blade attachment
screws/washers
center band
on motor housing
reverse switch
blade

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido