Testing Your Fan - Craftmade Targas TG52 Guia De Instalacion

12. Testing Your Fan.

It is recommended that you test fan before
finalizing installation. Slide the knobs to "O"
(OFF) position in wall control. Restore power
from circuit box. Test light and dimmer
function and then test fan speeds. If fan
and/or light do (does) not function, please
refer to "Troubleshooting" section to solve
any issues before contacting Customer
Service.
Turn fan completely off before moving the
reverse switch. Set reverse switch to
recirculate air depending on the season:
- LEFT position in summer (diagram 1)
- RIGHT position in winter (diagram 2)
A ceiling fan will allow you to raise your
thermostat setting in summer and lower
your thermostat setting in winter without
feeling a difference in your comfort.
Important: Reverse switch must be set
either completely LEFT or completely RIGHT
for fan to function. If the reverse switch is set
in the middle position (diagram 3), fan will
not operate.
diagram 1
page 9
motor housing
reverse switch
diagram 2
diagram 3