Fuel System Inspection And Maintenance - Rheem GEN12AD-V Manual De Operario

Sistema generador doméstico
Ocultar thumbs Ver también para GEN12AD-V:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Clean Air Cooling System
Generator maintenance consists of keeping the unit clean.
Operate the unit in an environment where it will not be
exposed to excesive dust, dirt, moisture or any corrosive
vapors. Cooling air louvers on the enclosure must not become
clogged with snow, leaves, or any other foreign material. To
prevent generator damage caused by overheating, keep the
enclosure cooling inlets and outlets clean and unobstructed at
all times.
Check the cleanliness of the unit frequently and clean when
dust, dirt, oil, moisture or other foreign substances are visible
on its exterior/interior surface. Inspect the air inlet and outlet
openings inside and outside the enclosure to ensure air flow
is not blocked.
Over time debris may accumulate in cylinder cooling fins
and cannot be observed without partial engine disassembly.
Unobstructed air flow is critical for correct generator
operation. For this reason, we recommend you have an
authorized Service Dealer clean the cooling system per
recommended intervals (see Maintenance Schedule in the
Maintenance Section). Equally important is to keep top of
engine free from debris. Make sure the oil cooler fins are free
of dirt and debris.
NOTICE Improper treatment of generator could damage it
and shorten its life.
generator. Water can enter the engine and generator and
cause problems.
dirt, or corrosive vapors.
Clean the generator as follows:
ows:
ows:
1. Use a damp cloth to wipe exterior surfaces clean.
2. Use a soft, bristle brush to loosen caked on dirt, etc.
3. Use a vacuum cleaner to pick up loose dirt and debris.
4. Use low pressure air (not to exceed 25 psi) to blow
away dirt. Inspect cooling air slots and openings in
the generator. These openings must be kept clean and
unobstructed.
22
ex
ext
or surfaces c
or surfaces c
n. n.
sen caked
sen caked
dirt, etc.
dirt, etc.
oo
oos
irt and debri
irt and debri
5 psi) to blo
5 psi) to blo
pen
penin

Fuel System Inspection and Maintenance

Natural Gas/Propane Fuel System
The fuel system installed on this engine has been designed
to various standards to ensure performance and reliability.
To ensure compliance to these standards, follow the
recommended maintenance schedule contained in this
section.
NOTICE The fuel system components have been specifically
designed and calibrated to meet the fuel system requirements
of the engine. If a fuel system component fails to operate or
develops a leak, it should be repaired or replaced with the
OEM recommended replacement parts.
Pressure Regulator Maintenance and Inspection
the mounting bolts are tight.
Venturi/Throttle Control Device Maintenance and Inspection
NOTICE A dirty air cleaner may significantly alter the venturi
r may sign
may sign
performance.
mounted.
d. d.
recommende
recommended maintenance schedule found in this
ecommend
section.
section.
section.
hose for cracking, splitting, or chaffing, Replace if any of
ho ho
these conditions exist,
Replace if any of these conditions exist.
Exhaust System Maintenance and Inspection
When inspecting the exhaust system, check the following:
and that all retaining bolts and shields (if used) are in
place.
ce ce

Publicidad

Tabla de contenido
loading

Tabla de contenido