Important - GAPOSA QCTX1 Manual De Instrucciones

INTERMEDIATE POSITION SETUP
(Just for motors with electronic limit switch))
Stop the shutter/awning in the desired intermediate po-
sition, then press simultaneously the UP (1) and DOWN
(3) buttons until the motor makes a brief movement in
both directions.
The intermediate position has been setup.
RECALLING THE INTERMEDIATE POSITION
Keep the STOP (2) button pressed at least for 3
seconds: the shutter/awning will move till it reaches
the intermediate position.
ERASING THE INTERMEDIATE POSITION
Press simultaneously the UP (1) and DOWN (3) buttons
until the motor makes a brief movement in both direc-
tions.
CHANNEL MANAGEMENT (QCTX2/5)
By pressing SEL (6), you pass through the channels
sequentially in this order:
■ Last channel/
used
■ Channel 1
■ last channel/
group used
■ Channel 1
■ Channel 2
Once the desired channel selected, you can proceed to
activate the corresponding motor by using UP (1), STOP
(2) and DOWN (3) buttons. Moreover, you can also me-
morize up to 8 combinations of groups of channels.
CREATING A GROUP OF CHANNELS
1. Select by SEL (6) the first channel to which you will
add the rest.
2. Press and hold SEL (6) until the next channel's LED
starts to flash.
3. By SEL (6) select the channel to be added.
4. To confirm the channel to be added hold SEL (6). The
channel LED will stop flashing and remain lit then the
next channel starts to flash.
5. Continue this sequence until all the desired channels
are added.
6. To memorize the group press STOP (2) or wait that
the LEDs turn off.
QCTX2
■ All channels
■ Channel 2
QCTX5
■ ...
■ All channels
■ Channel 5
■ Channel 4
■ Channel 3
SELECTING A MEMORIZED GROUP OF CHANNELS
With all the LEDs off, press SEL (6) and hold: the channels
of the last group created will turn on.
By pressing SELECTION again you pass through the
memorized groups.
By selecting the desired group you can activate the motors
by UP (1), STOP (2), DOWN (3).
IMPORTANT: you can select the 8 last memorized
combinations.
The memorization of further groups will require to
delete the already memorized channels starting from
the oldest.
BATTERY SUBSTITUTION
1. Remove the screw on the back and the cover.
2. Remove the old battery
3. Insert the new battery respecting the correct polarity.
IMPORTANT: Batteries contain polluting substances.
After removing, throw them in the designated batteries
collection points.