Safety Advice - Krups Nespresso FNA1 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 26
English
Thank you for chooinsg this appliance from
the KRUPS range.
Description
a
Removable water tank with lid
b
Function selector
c
Start/ stop switch
d
«Steam» function button «
e
Temperature indicator light
f
Capsule holder head
f1
opening and closing handle
f2
capsule cage
f3
capsule holder
g
Steam /hot water nozzle
h
Cappuccino accessory
i
Drip tray with removable grille
i1
fill indicator
j
Container for used capsules

Safety advice

• Please read these instructions carefully
before using your appliance for the first
time and retain them for future use: any
use which does not conform to the
instructions will absolve KRUPS from
any liability.
• Do not leave this appliance within reach
of unsupervised children. The use of this
appliance by young children or by
disabled persons must be supervised at
all times.
• Check that the voltage indicated on the
information plate on the appliance does in
fact match that of your electrical system.
• Only use an earthed socket to connect the
appliance.
Wiring instructions for U.K and Ireland
only :
APPLIANCES WITH FITTED PLUG
Important : For your convenience this
appliance is supplied complete with a plug
incorporating a 13 amp fuse.
In the event of replacing a fuse in the plug
supplied, a 13 amp fuse approved by ASTA to
BS1362 must be used.
If the socket outlets are not of the 13A BS
1363 type, and therefore do not accept the
plug connected to this appliance, cut off the
plug if moulded type or remove the plug if
connected by screw terminals.
When the plug is a moulded type and this is
cut off from the appliance, the connected
wires are a shock hazard. Do not under any
circumstances connect a cut off plug into the
electrical socket outlet. The cut off plug must
»
be disposed of in a safe manner that prevents
any form of connection.
If the fuse cover is detachable, never use the
plug with the cover omitted. Replacement
covers can be obtained from your service
agent.
Fit the appropriate plug according to the
instructions in paragraph "Fitting a plug".
With alternative plugs a 15 amp fuse must be
fitted either in the plug or adaptor or at the
main fuse box.
APPLIANCES WITHOUT FITTED PLUG
FITTING A PLUG - IMPORTANT
The wires in the mains lead are coloured in
accordance with the following code:
GREEN & YELLOW
BLUE
BROWN
As the colours in the mains lead of this
appliance may not correspond with the
coloured markings identifying the terminals in
your plug, proceed as follows:
The wire which is coloured GREEN & YELLOW
must be connected to the terminal in the plug
which is marked with the letter 'E' or by the
earth symbol
and yellow. The wire which is coloured BLUE
must be connected to the terminal which is
marked with the letter 'N' or coloured black.
The wire which is coloured BROWN must be
connected to the terminal which is marked
with the letter 'L' or coloured red.
This appliance is manufactured to conform to
the Low Voltage Electrical Equipment (Safety)
Regulations 1989 and is designed to comply
with BS 3456. It complies with the
requirements of the EEC Directive (89/336/
EEC).
Any connection error will nullify the
guarantee.
: EARTH
: NEUTRAL
: LIVE
or coloured green or green
11

Publicidad

Tabla de contenido
loading

Tabla de contenido