Reset Function; Default Settings - Philips AVENT SCD535 Instrucciones Importantes De Seguridad

EngliSh
20

reset function

This function in the menu of the parent unit allows you to reset both the parent unit and the baby
unit to the default settings at the same time. You can use this function if problems occur that you
cannot solve by following the suggestions in chapter 'Frequently asked questions'.
1 Select 'Settings' with the + and - buttons (Fig. 33).
2 Press the OK button to confirm.
3 Select 'Reset' with the + and - buttons.
4 Press the OK button to confirm.
The message 'Confirm?' appears on the display of the parent unit.
,
5 Press the OK button to confirm.
The parent unit switches off and then switches on again.
,
The units have now both been reset to the default factory settings.
,

Default settings

Parent unit
- Vibration alert: off
- Language: English
- Loudspeaker volume: 1
- Microphone sensitivity: 5
- Sound alert: off
- Temperature alert: off
- 'Temperature low' alert: 57°F (14°C)
- 'Temperature high' alert: 86°F (30°C)
- Temperature scale: Celsius
- ECO mode: off
Baby unit
- Loudspeaker volume: 3
- Nightlight: off
- Lullaby: off
accessories
Belt clip and neck strap
If the battery pack of the parent unit is sufficiently charged, you can take the unit with you inside and
outside the house if you attach the unit to your belt or waistband with the belt clip or if you hang it
around your neck with the neck strap. This allows you to monitor your baby while you are moving
around.
Connecting the belt clip
1 Snap the belt clip onto the parent unit (Fig. 35).
Disconnecting the belt clip
1 Pull the belt clip off the parent unit.
Connecting the neck strap
1 Insert the end loop of the neck strap through the hole behind the strap post. Thread the
neck strap through the end loop and pull the neck strap tight (Fig. 36).