Cleaning Your Hard Floors - Bissell CROSSWAVE 1785 Serie Manual Del Usaurio

Cleaning Your Hard Floors

1
Plug machine into a
properly grounded
outlet.
4
Before each use, hold the solution
spray trigger for 10 seconds to
prime the system with cleaning
solution. LED lights illuminate
when holding the trigger.
NOTE: When solution is flowing,
you will see bubbles forming
at the edges of the brush roll
window.
TIP: When cleaning excessively dirty or muddy hard floors or if your brush
roll looks dirty, use the Easy Clean Storage Tray to rinse your brush roll before
cleaning your area rugs.
TIP: For overly challenging and stuck-on messes on your hard floors, activate
the RUG mode and hold your CrossWave™ over the mess. Using short passes
while holding the trigger allows the multi-surface brush to go to work.
2
Select cleaning mode:
To start cleaning your hard
floors, turn the machine ON
pressing the HARD FLOOR
button. Once the setting is
selected, the dry vacuum will
turn on. To turn OFF, press
the HARD FLOOR setting a
second time.
5
To clean, hold the
solution spray trigger to
apply solution on both
forward and backward
passes.
3
Recline the body of
the machine backward
to start the brush roll
spinning. To stop the
brush roll spinning, you
will need to stand the
machine upright.
6
To dry hard floors
faster, release the
trigger and clean a
second pass without
dispensing solution.
www.BISSELL.com
7