Bissell CROSSWAVE 1785 Serie Manual Del Usaurio página 8

Cleaning Area Rugs
NOTE: Before cleaning area rugs, test an inconspicuous area of the rug for
colorfastness. Also, please check manufacturer's tag before cleaning area rugs for
any specialized cleaning instructions. Not for use on silk or delicate area rugs.
1
Plug machine into a
properly grounded
outlet.
4
Before each use, hold the solution
spray trigger for 10 seconds to prime
the system with cleaning solution.
LED lights illuminate when holding
the trigger.
NOTE: When solution is flowing,
you will see bubbles forming at the
edges of the brush roll window.
NOTE: The RUG button dispenses twice the solution of the HARD FLOOR button
to help with area rug cleaning.
TIP: For the most thorough clean, make 4 wet passes and 4 dry passes using
overlapping strokes over each area you clean on your rugs.
ATTENTION
Do not over wet carpet. Be careful not to run over loose objects or edges of area rugs.
Stalling the brush may result in premature belt failure.
8
www.BISSELL.com
2
Select cleaning mode:
To start cleaning your rugs,
turn the machine ON pressing
the RUG button. Once the
setting is selected, the dry
vacuum will turn on. To turn
OFF, press the RUG setting a
second time.
5
To clean, hold the
solution spray trigger
to apply solution on
both forward and
backward passes.
3
Recline the body of
the machine backward
to start the brush roll
spinning. To stop the
brush roll spinning, you
will need to stand the
machine upright.
6
To dry area rugs
faster, release the
trigger and clean
a second pass
without dispensing
solution.