Akron STYLE 3578 STREAMMASTER Instrucciones De Instalación, Funcionamiento Y Mantenimiento página 14

Figure 4
The.Elevation.stop.position.and.their.corresponding.stop/plug.configurations.are.shown.in.the.table.below . . .The.HOLE.
LOCATION.for.the.plug/stop.is.referred.to.by.an.angle.from.the.horizontal . . .The.OUTLET.ANGLE.is.the.angle.trajectory.
(from.horizontal).the.water.will.flow.from.the.StreamMaster.unit .
15°
P
P
S
P
S
S
P=PLUG S=STOP PS=PERMANENT STOP
Factory.Set.Stops
Note.that.the.permanent.stop.must.remain.installed . . If.this.stop.is.removed,.the.outlet.will.go.past.vertical.and.the.gear.
will.run.out.of.travel .
There.are.six.options.for.the.customer.to.use . . .This.is.achieved.with.3.plugs,.1.permanent.stop,.and.2.stops.provided.(the.
unit.will.be.assembled.with.the.permanent.stop.in.0°.location,.1.stop.in.the.-45°,.and.plugs.in.the.remaining.15°.and.-60°.
locations) . . The.parts.kit.will.contain.1.stop.and.1.plug . .
Elevation Stops
Hole Location
0° -45°
PS S
PS P
PS P
PS P
PS P
PS S
15°
-45°
-60°
Page.12
Lower Out-
let Angle
-60°
P -45°
S -45°
P -30°
P -45°
S -30°
P -30°
Upper Out-
let Angle
45°
30°
90°
90°
30°
45°