Sleep Operation - Denver CRL-310 Instrucciones De Uso

SNOOZE FUNCTION (MAIN UNIT)
When the alarm source is sounding, press the unit any buttons
(except on/off button (14)) or the remote control SNOOZE button (3)
to suspend the alarm and activate the snooze function. The Alarm
will temporarily stop and sound again 9 minutes later but the AL1 (or
AL2) indicator will keep flashing.
Notes:
This manual snooze operation can be repeated again and again.
To turn off the snooze function, Press the main unit on/off button
(14) or the remote control on/off button (1). The AL1 (or AL2)
INDICATOR will stop flashing

SLEEP OPERATION

The sleep timer allows you to turn the unit off after a designated
time has elapsed.
1. While listening to the radio, tap the unit button SLEEP button
(8) or the remote control button (3) the sleep time '90' (minutes)
appears in the LED DISPLAY.
2. Repeatedly tap the SLEEP button to select a sleep timer of 90,
60, 30 or 15 minutes. Wait for about 10 seconds after your
selection for the unit to confirm the selection, the unit will play
for the selected length of time then turn itself 'Off' automatically.
3. To cancel the sleep timer, repeatedly tap the SLEEP button until
you see the current time in the LED DISPLAY after last sleep
timer option (15 minutes).
• This function can be cancelled with the button (14).
4. This function can be cancelled with the unit button (14) or the
remote control button (1).
Note:
There is no sleep indicator in this unit. To check the remaining sleep
time, tap the SLEEP button once.
Nap alarm
The nap alarm can be used for e.g. a short "nap". The function only
operates in standby.
• Press the unit button (11) or the remote control button (11) to
select the time after which the device will beep. Select from 90
to 10 minutes or OFF (off) in steps of 10 minutes.
• After the selected time has elapsed, an increasingly fast beep
will sound. Use the unit button (14) or the remote control button
(1) to turn off the beep.
ENG-10