Enregistrer" [Save] Menu (Handset/Base Pairing); Keyboard Lock; Settings Available In The Strike Plate Module - THOMSON 512190 Manual Del Usuario

Wireless audio intercom
5 - "ENREGISTRER" [SAvE] MENU (HANDSET/
bASE PAIRING)
The handset can be paired with the base. This
operation is pre-configured in the factory. Normally,
you do not need to do this. The procedure is as
follows:
• Press and hold the pairing key located on the
base for at least 5 seconds.
• Then, select the "enregistrer" [save] menu on
the handset.
• If the base is nearby, the monitor then requests
the PIN code to finish the operation ("0000" by
default).
• The monitor will then emit a beep and the
procedure is finished.

6 - KEYbOARD LOCK

• To lock the keyboard and prevent accidentally
pressing the keys, press and hold the
key.
• Press and hold again to unlock.
• To completely turn off the handset, press and
hold the key.
• Press and hold again to turn it back on, or
place it on its base. When it is off, the handset
no longer rings for phone calls or visitors.
• To find the handset in case of loss, press the
pairing button located on the base to make the
handset ring if it is nearby.
7 - SETTINGS AvAILAbLE IN THE STRIKE
PLATE MODULE
• Depending on the type of connected device,
the strike plate module can be used in normally
closed contact (closed when at rest, open
when access is made to a visitor) or normally
open (open at rest, closed when access is
made to a visitor).
• Use the strike plate module interior selector to
select the desired mode (NO or NC).
E - OpErATiON
• You can define the amount of time for which the
door is open using a "Timer adj" potentiometer.
• Turn the adjustment screw counter-clockwise
to reduce this duration (minimum: about 0.5
seconds).
• Turn the adjustment screw clockwise to
increase this duration (maximum: about 10
seconds).
EN
15