Briteq BTX-FALCON Manual De Instrucciones página 7

ENGLISH
 Blackout mode: when no DMX-signal is detected, the unit goes in blackout and waits for the DMX-signal.
 Select "Offline Mode" and press ENTER
 Use DOWN / UP buttons to select one of the available options.
 Press the ENTER button to save.
To return to a previous menu, press the MENU button.
Show Mode
Used to choose the Show mode when used in standalone or master/slave mode.
 Select "Show Mode" and press ENTER
 Use DOWN / UP buttons to select one of the available Shows.
 Press the ENTER button to save.
To return to a previous menu, press the MENU button.
Slave Mode
Used to make the slave unit work in opposite to the master or to work in complete sync.
 Select "Slave Mode" and press ENTER
 Use DOWN / UP buttons to select one of the available options:
 Slave1: the slave follows the master in complete sync
 Slave2: the slave follows the master in opposite sync
 Press the ENTER button to save.
To return to a previous menu, press the MENU button.
Focus 1
Used to help you adjusting the focus of the rotating gobos (gobo wheel 1) while used in standalone
mode.
 Select "Focus 1" and press ENTER: the projector shows one of the rotating gobos so you can easily
adjust the focus.
 Use DOWN / UP buttons until the gobo is sharp (value range: 0-255)
 Press the ENTER button to save.
To return to a previous menu, press the MENU button.
Remark: please note that you can only set an "average focus" , while in standalone mode it is not possible to
set the focus perfectly sharp for all directions.
Focus 2
Used to help you adjusting the focus of the fixed gobos (gobo wheel 2) while used in standalone
mode.
 Select "Focus 2" and press ENTER: the projector shows one of the fixed gobos so you can easily adjust
the focus.
 Use DOWN / UP buttons until the gobo is sharp (value range: 0-255)
 Press the ENTER button to save.
To return to a previous menu, press the MENU button.
Remark: please note that you can only set an "average focus" , while in standalone mode it is not possible to
set the focus perfectly sharp for all directions.
Sound Trigger
If switch on, the unit works to rhythm of the beat while used in standalone or master/slave mode
 Select "Sound Trigger" and press ENTER
 Use DOWN / UP buttons to select:
 On: internal shows triggered by the internal microphone
 Off: internal shows triggered at a preset slow speed.
 Press the ENTER button to save.
To return to a previous menu, press the MENU button.
Sound Sensitivity
Used to set the sensitivity of the internal microphone while used in standalone or master/slave mode
 Select "Sound Sensitivity" and press ENTER
 Use DOWN / UP buttons to change the sensitivity from 0 (very low sensitivity) to 100 (high sensitivity).
 Press the ENTER button to save.
To return to a previous menu, press the MENU button.
BRITEQ
®
5/79
OPERATION MANUAL
BTX-FALCON