Shindaiwa C4 Serie Manual Del Propietario - Operador página 9

Assembly (continued)
Installing Brushcutter Blade
WARNING!
Do not attach any blade to
a unit without proper installation of
all required parts. Failure to use the
proper parts can cause the blade to
and/or bystanders.
1. Turn the unit upside down so the gear
case output shaft is facing UP and
remove the shaft bolt, bolt guard and
holder B from the gear case shaft.
2. Align the hole in blade holder A with
the matching hole in the gear case
flange and then temporarily lock the
output shaft by inserting a hex wrench
through both holes.
3. Slide the safety clip off-center
4. Fit the blade over the safety clip and then
center it over the flange on holder A.
Lock the blade in place by centering the
safety clip on the output shaft.
WARNING!
hole must be centered over the raised
boss on blade Holder A.
CAUTION!
Install the blade so its printed surface
is visible to the operator when the
brushcutter is in the normal operating
position.
5. Install blade holder B on the output shaft.
The recess in the holder must completely
cover the safety clip, and must fit tightly
against the blade.
WARNING!
the blade and the splines engaged to
the output shaft.
Shaft Bolt
Bolt Guard
Holder B
Hex
Wrench
Blade Holder B
6. Install the bolt guard and then the blade
retaining bolt. Using the combination
spark plug wrench/screwdriver, tighten
the bolt firmly in a counter-clockwise
direction.
7. Remove the hex wrench.
Slide the safety clip off-center
Safety Clip
Gear shaft
Safety Clip
Holder A
Slip the Saw Blade
In Place
Output Shaft
Blade
Hex Wrench
The unit should now be
completely assembled and ready
for use with a blade.
Discard blades that are bent, warped,
cracked, broken or damaged in any way.
Use a sharp blade. A dull blade is more
likely to snag and thrust.
Output Shaft
Slide the Safety Clip
Back
Tighten the assembly
(blade not shown for
clarity)
IMPORTANT!
9