Pairing Procedure - A&D Medical PROCONNECT 651 Serie Manual De Instrucciones

Using the Monitor

Pairing procedure

1. Follow the instructions in the manual of the receiver device to
switch it to the pairable status. When pairing this monitor, place
it as close as possible to the receiver device to be paired with.
2. Install the batteries or connect the AC adapter.
Press and hold the "START" button until "Pr" is
displayed, then release the button.
The monitor will be in a state that can be found by
the receiver device for about one minute.
3. The monitor displays "End" to indicate that pairing is
complete.
4. If "Err 10" is displayed or pairing is failed, remove the
batteries or disconnect the AC adapter and try steps
1-3 again.
5. Follow the manual of the pairing receiver device to search for,
select and pair with this monitor.
Communication Distance
The communication distance between this monitor and the
receiver device is about 33 feet (10 m). This distance is reduced
by the conditions in the surrounding environment, so be sure to
check that the distance is short enough for a connection to be
made after measurement is complete.
E-12