Quick Installation; Optional Installation - Tripp-Lite BC Pro Serie Manual De Operación

Quick Installation

Plug your UPS into an
1
electrical outlet.
Plug your computer,
2
monitor and external
modem into battery-
supported outlets. Plug
other equipment into
surge-only outlets.*
Set your UPS's "OFF –
3
ON" Switch.**
USA, Canada & Western Europe
· Set it and leave it "ON" at all times.
All Other Countries
· Set to "OFF" when you are not using
connected equipment.
(WARNING! When set to "OFF," UPS will not
provide battery backup during a blackout or
brownout)
· Set to "ON" when you are using connected
equipment.
* Separate battery-supported/surge and surge-only outlets are available only on select models (identified on the
back of your UPS). Your UPS is designed to support only computer equipment. You will overload your UPS if you
connect household appliances, laser printers or surge suppressors. ** See Basic Operation section for the Switch
Function, UPS Conditions and Setting Advantages.

–Optional Installation–

(select models)*
OPTION 1 (Phone-Line Surge Suppression)
Using telephone cords, connect your wall
jack to the UPS jack marked "LINE" (or
"IN"). Connect your equipment to the UPS
jack marked "EQUIP" (or "OUT").
OPTION 2 (UPS Software)
Using Tripp Lite Cable (if supplied) connect
the DB9 port of your UPS to the DB9 port of
your computer. Load software (if supplied)
and run the installation program appropriate
for your operating system.
OPTION 3 (Brownout Voltage Adjustment)
Adjust the Voltage Potentiometer (UPS back
panel) clockwise to lower the voltage point
at which the UPS switches from on-line to
battery output.**
* Your UPS will function properly without these
connections or settings. ** Use caution when
adjusting the potentiometer while the UPS is
powering a voltage-sensitive load.
9906091--BC Pro 120V OM (5.5, 5.6).p65 3
OPTIONS 1 & 2
OPTION 3
NORM
10/14/99, 2:35 PM
3