Quick Installation - Tripp-Lite SmartPro 2U Manual Del Propietário

Quick Installation

Plug the UPS into an outlet on
1
a dedicated circuit.
Note: After you plug the UPS into a live AC
outlet, the UPS (in "Standby" mode) will
automatically charge its batteries, but will
not supply power to its outlets until it is
turned ON.
Plug your equipment into
2
the UPS.*
* Your UPS is designed to support only electronic
equipment. You will overload the UPS if the total
VA ratings for all the equipment you connect
exceeds the UPS's Output Capacity. To find your
equipment's VA ratings, look on its nameplates.
If the equipment is listed in amps, multiply the
number of amps by 120 to determine VA.
(Example: 1 amp × 120 = 120 VA) If you are
unsure if you have overloaded the UPS's outlets,
see LOAD icon description in LCD Interface
section under Basic Operation.
Turn the UPS ON.
3
Press and hold the
second. The alarm will beep once briefly.
Note: UPS system will function properly upon initial
startup, however, maximum runtime for the unit's
battery will only be accessible after it has been
charged for 24 hours.
201205048 93-3149.indb 6
1
2
button for one
A
3
6
A
6/19/2012 11:33:34 AM