Quick Installation - Tripp-Lite AG-SM7145 Serie Manual Del Propietário

Quick Installation

Insert a user-supplied power cord
1
(with country-specific plug) into the
UPS System's IEC-320-C20 AC input
receptacle. Plug the cord into an AC
wall outlet.*
NOTE! after you plug the UPS into a live AC
outlet, the UPS (in "Standby" mode) will
automatically charge its batteries,** but
will not supply power to its outlets until it is
turned ON.
* See the UPS system nameplate for input requirements.
** The BATTERY CHARGE LED will be the only LED
illuminated.
Find one of the C13-to-C14 power
2
cords that came with the UPS.
Insert the cord's female plug into
your computer's AC input. Insert
the cord's male plug into any UPS
female output receptacle.
Plug your equipment into the UPS.*
3
Plug your equipment into the UPS. Repeat
the previous step, using the additional
power cord(s) included with the UPS
system.
Note: Additional interconnection cords
(C13-to- C14) are available from Tripp Lite.
Call +1.773.869.1234 (Part # P004-006).
* Your UPS is designed to support computer equipment
only. You will overload the UPS if the total VA ratings
for all the equipment you connect exceeds UPS output
capacity. To find your equipment's VA ratings, look on
their nameplates. If the equipment is listed in amps,
multiply the number of amps by 230 to determine VA.
(Example: 1 amp × 230 = 230 VA).
If you are unsure if you have overloaded your UPS
system's outlets, see "OUTPUT LOAD LEVEL " LED
description.
Turn the UPS ON.
4
Press and hold the "ON/OFF/STANDBY"
button for one second. The alarm will beep
once briefly after one second has passed.
Release the button.
1
2
3
4
6