Krups EA815 Manual De Instrucciones página 32

Rinsing the circuits :
Press the maintenance and settings button
nance button .
If necessary, using the navigation button,
Press START , rinsing starts and finishes when the coffee menu appears.
Automatic rinsing of the circuits when the machine starts.
You can choose to program the machine to be rinsed automatically each time it is turned on. To do this,
press the maintenance and settings button
rinsing programming symbol
press the , button, automatic rinsing is disabled.
You can return to the coffee types menu by pressing the
Warning: after this rinsing process, hot water will be released from the coffee outlet. Ensure that the drip
tray is in place even when the machine is not being used. The cycle lasts only a few seconds and stops au-
tomatically.
Cleaning program - total duration: approximately 13 minutes
You do not have to run the cleaning program as soon as the appliance requests it, but it must be done rea-
sonably soon after. If cleaning is postponed, the alert message will remain illuminated until the process is car-
ried out.
When the symbol lights up, you can run the automatic cleaning program by pressing the maintenance
and settings button
maintenance button
The automatic cleaning program is divided into 2 stages: the cleaning cycle itself, followed by the rinse cycle.
You can clean the machine at any time by pressing the maintenance and settings button
navigation button
To run this cleaning program, you will need a container which holds at least 20 oz and which can be placed
beneath the coffee outlet and the steam nozzle. The
Lift the cup tray fig.28.
Insert the KRUPS cleaning tablet fig.29.
Fill the water container to its maximum level of 57 oz fig.2.
Empty the coffee grounds collector and the drip tray and clean the coffee drawer fig.23-24-25.
Put a 0.6 L (21 oz) container under the coffee and steam jets fig.30.
Press START
When this phase has finished, empty the container and the drip dray. The
back in place.
Press START
When this phase has finished, empty the container and the drip tray. The cycle has finished, the coffee
types menu appears.
Note: if you turn off or unplug your machine during cleaning or if there is a power failure, the cleaning program
will start from the beginning of the program once the power is restored to the appliance. It is not possible to
postpone this process. It is obligatory in order to rinse the water circuit. In this case, a new cleaning tablet
may be necessary. It is best to run the full cleaning program in order to avoid any risk of poisoning. The
cleaning cycle is irregular: do not put your hands under the coffee outlet while the cycle is running.
Descaling program - duration: approximately 20 minutes
You do not have to run the descaling program as soon as the appliance requests it, but it must be done rea-
sonably soon after. If descaling is postponed, the alert message will remain illuminated until the process is
carried out.
The amount of limescale collected depends on the hardness of your water.
Warning: if your product is fitted with our Claris - Aqua Filter System cartridge, remove the cartridge before
descaling.
3
. Press the
. The symbol is selected. The function indicator
.
select the cleaning symbol
. The symbol becomes constant. The first phase (approximately 10 minutes) begins.
. The symbol becomes constant, the final phase (approximately 3 minutes) begins.
fig.27. The function indicator
select the rinse symbol
fig.27. Using the navigation button
button to choose ON which confirms this program. If you
button.
.
symbol flashes.
is shown above the mainte-
.
, select the automatic
is shown above the
then, using the
symbol flashes. Put the parts