Set Contents; Setting Up The Transmitter; Setting Up The Receiver - Marmitek GIGAVIDEO 580 Modo De Empleo

2. SET CONTENTS

1 A/V Transmitter
1 A/V Receiver
2 Power adapters
1 IR Extender cable with 2 LEDs.

3. SETTING UP THE TRANSMITTER

1. Connect one set of cables to the AUDIO-[D] and VIDEO [C] input of your Marmitek
GigaVideo Transmitter. Make sure to match the colours of the plugs on the cable with the
jacks on the GigaVideo Transmitter.
2. Connect the other end of the cable to the Audio/Video OUT jacks of the video source
you want to transmit the signal from (e.g. your VCR, DVD, Satellite or TV: connecting the
transmitter to your VCR or Satellite receiver, allows you to choose channels independent
from your main TV). If your video source is equipped with a SCART connector use the
SCART Adapter labelled Transmitter.
3. Set the channel selector [A] (1-2-3-4) to 1.
4. Switch the power slide switch [B] to 'OFF'.
5. Plug the supplied power adapter into a wall outlet and connect the plug at the rear side of
the transmitter [E]. Only use the supplied power adapter!
6. Switch the power slide switch [B] to 'ON'.
7. Position the transmitter in a convenient location, preferably free on all sides, and orient the
antenna [K] so that the flat side faces the direction of the room where you will set up the
receiver.
If you have several A/V devices:
If you have two or more A/V devices that you want to watch in another room, they will
probably already be hooked up to the local TV in series. To connect the GigaVideo Transmitter
you just need to identify the last component in the chain and connect the LINE OUT or SCART
to the GigaVideo Transmitter IN jacks.

4. SETTING UP THE RECEIVER

1. Connect a set of Audio/Video cables to the LINE OUT jacks [H+I] of your GigaVideo
receiver. Take care to match the colours of the plugs on the cable with the jacks on the
GigaVideo receiver.
2. Set the channel selector [A] (1-2-3-4) to 1.
3. Switch the power slide switch [B] to 'OFF'.
4. Plug the supplied power adapter into a wall outlet and connect the plug to the backside of
the receiver [E]. Only use the supplied power adapter!
4
2 RCA cables (white / red / yellow)
1 SCART adapter (labelled Transmitter).
1 SCART adapter (labelled Receiver)
1 User manual
© MARMITEK