Tripp-Lite PDUMH30NET Serie Manual Del Propietário página 5

Installation
Cord Retention System (PDUMH32HVNET Only)
To assure a secure connection when plugging equipment into the PDU, use the
included cord retention system. Follow this procedure for each item of equipment you
connect:
3-1
Insert a cord retention strap
the mounting hole to the right of
the PDU outlet
until it locks in place. IMPORTANT:
when installing the cord retention
strap, ensure that its grooved
surface faces right. The strap will
not function properly if it is
installed with its grooved surface
facing left.
3-2
Plug the equipment into the PDU
outlet.
3-3 Slip a cord retention sleeve
the equipment power cord.
3-4
Slide the cord retention strap
through the slot on the cord
retention sleeve. Press out on the
small tab
to insert the strap; release it to
lock the strap in place.
3-5
Lock the cord retention sleeve over
the power cord by pressing back
the tab to engage the locking
threads.
3-6
Tighten the cord retention strap as
necessary to secure the power
cord against accidental
disconnection.
To disconnect equipment, press out on the slot tab to unlock the cord
retention strap and pull back the cord retention sleeve until it disengages.
201105095 93-3048.indb 5
into
A
, pressing firmly
B
over
C
at the front of the slot
D
B
3-1
3-2
3-3
3-4
3-5
5
Grooved Surface
A
C
D
6/15/2011 3:07:25 PM