Donning Procedure - Respirex CHEMPROTEX 300 COMBI Instrucciones De Uso

• When selecting outer gloves and boots it is recommended that consideration be given to their compatibility with the
electrostatic properties of the suit
• Always use compatible PPE, e.g. gloves and boots as advised by Respirex
• Flammable material. Keep away from fire
When worn alone a one-piece coverall provides only partial body protection. If full body protection is required always use
compatible PPE, e.g. gauntlets, boots and hoods advised by Respirex.
When worn with a face mask which is partially tape sealed to the integral hood under the chin and appropriate gloves and safety
boots, a one-piece coverall will meet the performance requirements of Type 3, Type 4, Type 5 and Type 6 clothing.
CHEMPROTEX™ 300 material does not breathe. The wearer's body temperature will rise whilst wearing the suit and care should
be taken not to lose too much body fluid. The wearer should leave the work area and remove the suit before becoming distressed.
For any enquiries please contact the Respirex customer services department on
Tel : +44 (0)1737 778600 or Fax : +44 (0)1737 779441
Pre-checks
1. Visually inspect the coveralls for any damage that may reduce the level of protection offered
2. The coveralls are free from contamination both internally and externally
3. The zipper operates correctly and the slider is in good condition
4. The coveralls are free from tears and holes. Pay particular attention to the seam areas
Wearer's instructions
Consult the body measurement chart (see page 11) and select one-piece coverall of a suitable size. It is the wearer's responsibility
to determine the protection required and to select the appropriate garment type. Suitable boots, gloves and respiratory equipment
must be worn with the one-piece coveralls for certain applications. In order to ensure a complete seal against fluid ingress,
Respirex recommends taping the hood to face mask, cuffs to gloves and ankles to boots using a suitable liquid impermeable
tape*. If the material becomes torn, abraded and/or punctured, the end user should discontinue use to avoid potential exposure to
hazard. Respirex International cannot accept responsibility for improper garment use.
*recommended tape width 75mm

Donning procedure

After carrying out the pre-checks as detailed above; open the suit fully and fit gloves where applicable as detailed in the glove
fitting instructions. Stand up and put arms into sleeves one at a time, fasten the zip, then make sure the outer flaps are closed
correctly. Put on safety boots as outlined in the instructions. Where applicable make sure the hood is worn correctly (see hood
instructions). Respirex recommends taping the hood, gloves and boots to prevent ingression of chemical contamination.
Wearing gloves with double elasticated sleeves
1. Put on the suit as usual
2. Roll back the outer sleeve (Fig.1) approximately 15 cm (6 inches)
3. Put on the glove with the inner sleeve of the suit to the inside of the glove (Fig.1)
4. Roll the outer elasticated sleeve down over the exterior of the glove (Fig.2)
Exactly the same procedure should be utilised when wearing suits with elasticated inner sleeves and straight outer sleeves.
Wearing gloves with single elasticated sleeves
1. Put on the suit as usual
2. Put on the glove with the elasticated sleeve of the suit to the inside of the glove (Fig.3)
3. Pull the elasticated sleeve over the glove (Fig.4)
Wearing gloves with SiverShield gloves
1. Put on the suit as usual with the SilverShield glove (Fig.5)
2. Put on the neoprene glove over the SilverShield glove (Fig.6)
2