Fluidmaster 400A Guía De Instalación Rápida página 3

STEP 2: REMOVE OLD FILL VALVE
A: REMOVE CONNECTOR
Remove water supply
connector from bottom
of fill valve by twisting
connector nut to the left
(clockwise).
NOTE: Inspect water
supply connector.
Replace it if it is worn, or
you don't know how old it is, to
Towel
prevent flooding and property damage.
(Optional)
B: REMOVE OLD LOCKNUT
Below tank, twist locknut
to the left (clockwise) to
remove from fill valve.
C: REMOVE OLD FILL VALVE
Including refill tube, refill
clip and shank washer.
Drain any excess water
into bucket by removing
fill valve from tank.
(Pull fill valve up)
Bucket
(Optional)
4
LEFT
LEFT
STEP 3:
ADJUST HEIGHT OF NEW FILL VALVE
A: TWIST FILL VALVE TO ADJUST HEIGHT
Top of fill valve cap should measure roughly 3"
above top of overflow pipe when installed.
NOTE:
Increasing height allows
more water to fill in the tank.
TWIST
LEFT
Fill Valve Cap
*Lever Hole
*
The top of the overflow pipe must be a minimum of 1" below tank lever hole.
HOLD
Do Not Move Lock Ring
TOP OF FILL VALVE CAP
3"
TOP OF OVERFLOW PIPE
Overflow Pipe
5