Environmental Notice - Braun 3 Serie Manual De Instrucciones

Cleaning
Regular cleaning ensures better shaving performance.
Cleaning under running water:
• Switch the shaver on (cordless). Rinse the shaver head and the precision mode
switch under hot running water until all residues have been removed. You may use
liquid soap without abrasive substances. Rinse off all foam and let the shaver run
for a few more seconds.
• Next, switch off the shaver, remove the Foil & Cutter cassette (1) and let it dry.
• If you regularly clean the shaver under water, then once a week apply a drop of light
machine oil (not included) onto the long hair trimmer (2) and Foil & Cutter cassette (1).
The shaver should be cleaned after each foam usage.
Cleaning with a brush:
• Switch off the shaver. Remove the Foil & Cutter cassette and tap it out on a flat surface.
• Using a brush, clean the inner area of the head. However, do not clean the shaver
Foil & Cutter cassette with a brush as this may damage it.
Keeping your shaver in top shape
Replacement light for shaving parts / Reset
To maintain 100% shaving performance, replace the Foil & Cutter cassette (1), when
the replacement light for shaving parts (7) comes on after about 18 months or when
worn.
Foil & Cutter cassette: 32S/32B
The replacement light will remind you during the next 7 shaves to replace the
Foil & Cutter cassette. Then the shaver will automatically reset the display.
After you have replaced the Foil & Cutter cassette (1), press the on/off switch (4) for at
least 5 seconds to reset the counter.
While doing so, the replacement light blinks and goes off when the reset is complete.
The manual reset can be done at any time.
Preserving the batteries
In order to maintain the optimum capacity of the rechargeable batteries, the shaver has
to be fully discharged by shaving every 6 months approximately. Then recharge the
shaver to full capacity.

Environmental notice

Product contains batteries and/or recyclable electric waste. For environment
protection do not dispose of in household waste, but for recycling take to electric
waste collection points provided in your country.
Subject to change without notice.
For electric specifications, see printing on the special cord set.
12