How To Use The Adjustable Nozzle - Briggs & Stratton Speed Clean 2300PSI Manual Del Propietário

Briggs & Stratton Generac Generator Discount Parts Call 606-678-9623 or 606-561-4983

How to Use the Adjustable Nozzle

You should now know how to START and STOP your
pressure washer.The information in this section will tell
you how to adjust the spray pattern and to apply detergent
or other cleaning chemicals.
WARNING!
spraying. NEVER put hands in front of nozzle to
adjust spray pattern.
1. Slide the nozzle forward when you wish to adjust the
spray to low pressure mode (Figure 10). Slide the
nozzle backward to achieve high pressure.
Figure 10 — Adjusting Nozzle for Pressure
Slide nozzle backward
for High Pressure
Mode
2. Point the nozzle down towards a firm surface and
press the trigger to test the pattern (Figure 11).
Figure 11 — Testing the Spray Pattern
Speed Clean™ 2300 PSI Pressure Washer
NEVER adjust spray pattern when
Slide nozzle forward for low
pressure mode and
detergent application
www.mymowerparts.com
3. Twisting the nozzle adjusts the spray pattern from a
narrow pattern to a fan pattern (Figure 12).
Figure 12 — Adjusting the Nozzle for Spray Pattern
Rotate nozzle
counterclockwise for fan
spray pattern
4. For most effective cleaning, keep spray nozzle from
8 to 24 inches away from cleaning surface.
5. If you get the spray nozzle too close, especially using
high pressure mode, you may damage the surface being
cleaned.
6. DO NOT get closer than 6 inches when cleaning tires.
Applying Detergent with the
Adjustable Nozzle
IMPORTANT: Use soaps designed specifically for
pressure washers. Household detergents could damage
the pump.
CAUTION!
You must attach all hoses before you start
the engine. Starting the engine without all the hoses
connected and without the water turned ON will damage
the pump.
To apply detergent, follow these steps:
1. Review the use of adjustable nozzles.
2. Prepare the detergent solution as required by the job.
3. Place the filter end of the chemical injection hose into
the detergent container.
CAUTION!
Keep the chemical injection hose from
coming in contact with the hot muffler.
9
Rotate nozzle clockwise
for narrow spray pattern