How To Stop Your Pressure Washer; How To Use The Adjustable Nozzle - Briggs & Stratton GENERAC 2300PSI Manual Del Propietário

Ocultar thumbs Ver también para GENERAC 2300PSI:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

• Return the starter grip handle slowly. Do Not let rope
"snap back" against starter.
• When engine starts, slowly move choke lever to the
"Run" position. If engine falters, move choke lever to the
"Choke" position, then to the "Run" position.
• If engine fails to start after six pulls, move choke lever to
the "Run" position. If engine fires, but does not continue
to run, move choke lever to the "Choke" position, then
to the "Run" position.
NOTE: If the recoil starter is hard to pull, it may be necessary
to squeeze the gun trigger to relieve internal pump pressure.

How to Stop Your Pressure Washer

• Move throttle lever on engine to "Stop" position.
• Squeeze trigger on the spray gun to relieve
pressure in the hose.
NOTE: A small amount of water will squirt out when you
release the pressure.

How to Use the Adjustable Nozzle

You now should know how to START your pressure
washer and how to STOP it.The information in this
section will tell you how to adjust the spray pattern and
apply detergent or other cleaning chemicals.
CAUTION!
Never adjust spray pattern when
spraying. Never put hands in front of nozzle to
adjust spray pattern.
The adjustable nozzle affixed to the nozzle extension
permits you to adjust the spray pattern and the spray
pressure, as follows:
• Slide the nozzle forward to adjust the spray to low
pressure mode (Figure 10). Slide the nozzle backward to
achieve high pressure.
Generac Portable Products 2300 PSI Pressure Washer
• Point the nozzle down towards a firm surface and press
• Twisting the nozzle adjusts the spray pattern from a
8
Figure 10 - Adjusting Spray Pressure
Slide nozzle backward
for high pressure mode.
the trigger to test the pattern (Figure 11).
Figure 11 — Test the Spray Pattern
narrow pattern to a fan pattern (Figure 12).
Figure 12 - Adjusting Spray Pattern
Twist nozzle
counterclockwise for fan
spray pattern.
Slide nozzle forward for
low pressure mode and
detergent application.
Twist nozzle clockwise
for narrow spray
pattern.

Publicidad

Tabla de contenido
loading

Tabla de contenido