SOMFY Tilt&Lift 25 RTS Manual De Instrucciones página 21

Tilt & Li 25 RTS
Attention
To press on the motor PROG button, it's best to use the motor
antenna. The use of other tools could damage the PROG button.
2.4.2. Re-setting the end limits
2.4.2.1. Readjusting the upper end limit
1) Press the Up button to bring the motorised
product to the end limit to be readjusted.
2) Press the Up and Down buttons at the same
time until the motorised product moves up and
down.
3) Press the Up or Down button to move the
motorised product to the new desired position.
4) To confi rm the new end limit, press the my
button until the motorised product moves up
and down.
2.4.2.2. Readjusting the lower end limit
1) Press the Down button to bring the motorised
product to the end limit to be readjusted.
2) Press the Up and Down buttons at the same
time until the motorised product moves up and
down.
3) Press the Up or Down button to move the
motorised product to the new desired position.
4) To confi rm the new end limit, press the my
button until the motorised product moves up
and down.
2.4.3. Adding or deleting a RTS control point
Find an RTS control point (A) programmed in the
motor.
Press and hold the RTS programmed control
point (A) PROG button or the motor PROG button
until the motorised product moves up and down:
the motor is in programming mode.
Quickly press the RTS control point(B) PROG button to add or delete: the
motorised product moves up and down and the RTS control point is programmed
or deleted from the motor.
Copyright 2018 SOMFY ACTIVITES SA, Société Anonyme All rights reserved.
©
1 2
3
4
1 2
3
4
PROG.
A
PROG.
EN
B
21