Wiring; Commissioning - SOMFY Tilt&Lift 25 RTS Manual De Instrucciones

EN
2.1.3. Motor and sha locking
1) Using the relevant tool, pinch headrail edges to
block motor translation.
2) To lock the sha , place stop rings against the
CTS , and screw them.

2.2. WIRING

Danger
• Cables which pass through a metal wall must be protected and
isolated using a sheath or sleeve.
• Attach cables to prevent any contact with moving parts.
• Drive cable cannot be removed. If it is damaged, return the
drive to the A er-Sales department.
• To ensure electrical safety, this Class III motor must be powered
by a «SELV» voltage source (Safety Extra Low Voltage).
Attention
• Leave the motor power supply cable accessible: it must be
possible to replace it easily.
• Do not unplug the battery or the power supply when the motor
is working.
Plug the battery or the power supply with the
motor supply cable.

2.3. COMMISSIONING

2.3.1. Programming the RTS control point
Press the Up and Down buttons simultaneously
on the RTS control point: the motorised product
moves up and down and the control point is
preprogrammed in the motor
18 Copyright 2018 SOMFY ACTIVITES SA, Société Anonyme All rights reserved.
©
Tilt & Li 25 RTS
1 2