Panasonic ES-LV95 Instrucciones De Funcionamiento página 22

Problem
The STATUS lamp
glows.
The mode does not
start.
Cleaning liquid has
accumulated in the
cleaning tray.
22
Action
See page 25.
Check that the AC adaptor is
connected to the self‑cleaning
recharger, and that the
recharger is plugged in to a
household outlet.
(See page 13.)
Confirm that the shaver is
properly attached to the self‑
cleaning recharger.
(See page 13.)
The Clean or Dry operation
may not function under extreme
low temperatures (approx. 0 °C
or lower).
Check if the STATUS lamp
glows. (See page 25.)
Remove any waste, etc. that
has accumulated in the drain at
the bottom of the cleaning tray.
(See page 21.)
If you use the self‑cleaning
recharger when the shaver is
wet or when soap or shaving
gel is on the shaver, cleaning
liquid may accumulate in the
cleaning tray.
Problem
The cleaning liquid unit
cannot be removed.
Makes a loud sound.
The shaver cannot be
charged.
Action
Place the self‑cleaning
recharger on a hard, flat
surface.
When the self‑cleaning
recharger is lifted, or on the soft
surface such as carpets, the
lock release lever will not fit in
the recharger properly.
In that case, the cleaning liquid
unit cannot be removed.
During cleaning:
The self‑cleaning recharger
makes a loud sound due to
the cleaning of the blades.
After cleaning:
The self‑cleaning recharger
makes a loud sound due to
the removal of water droplets
in order to speed drying.
The sound after cleaning is
different from the sound during
cleaning. The water level has
dropped and it is removing
water droplets from the blades
after cleaning. This does not
indicate a problem.
Gently wipe the main body rear
terminals and the charging
terminals of the self‑cleaning
recharger with a cloth or tissue
dampened with water.