Nice Pop Manual Del Usuario página 62

Memorising a remote control
!
When the memorisation phase is activated, any trans-
mitter correctly recognised within the reception range of
the radio is memorised. Consider this aspect with care
and remove the aerial if necessary to reduce the capacity
of the receiver.
The procedures for memorising the remote controls must be per-
formed within a certain time limit; please read and understand the
whole procedure before starting. In order to carry out the following
procedure, it is necessary to use the button located on the box of
the radio receiver (reference A, Fig. 1b), and the corresponding LED
(reference B, Fig. 1b) to the left of the button.
Table "B1" Mode I memorising
(All buttons are memorised on the related receiver output)
1. Press and hold down the receiver button for at least 3 seconds
2. Release the button when the Led lights up
3. Push, for at least 2 seconds, any of the buttons of the transmitter to be memorised
within 10 seconds
N.B.: If the procedure was memorised correctly, the Led on the receiver will flash 3 times.
If there are other transmitters to memorise, repeat step 3 within another 10 seconds
The memorisation phase finishes if no new codes are received for 10 seconds.
Table "B2" Mode II memorising
(A specific receiver output can be associated to each button)
1. Press and release the receiver button as many times as the number of the
desired output (Once for output No. 1, twice for output No. 2)
2. Check that the LED emits the same number of flashes as the desired output, repeated
over 10 seconds in regular intervals (1 flash if output No. 1, 2 flashes if output No. 2)
3. Within 10 seconds press the desired button on the transmitter to be memorised,
holding it down for at least 2 seconds.
N.B.: If the procedure was memorised correctly, the Led on the receiver will flash 3 times.
If there are other transmitters to memorise, repeat step 3 within another 10 seconds
The memorisation phase finishes if no new codes are received for 10 seconds.
Remote memorising
It is possible to enter a new transmitter in the receiver memory
without using the keypad. A previously memorised and operational
remote control must be available. The new transmitter will "inherit"
the characteristics of the previously memorised one. Therefore, if the
first transmitter is memorised in mode I, the new one will also be
memorised in mode I and any of the buttons of the transmitter can
be pressed. If the first transmitter is memorised in mode II the new
one will also be memorised in mode II but the button activating the
Table "B3" Remote Memorising
1. Press the button on the NEW transmitter for at least 5 seconds and then release
2. Press the button on the OLD transmitter 3 times slowly
3. Press the button on the NEW transmitter slowly and then release
N.B.: If there are other transmitters to memorise, repeat the above steps for each new transmitter
18
required output must be pressed on the first transmitter as must the
button required to be memorised on the second. You need to read
all the instructions in advance so you can perform the operations in
sequence without interruptions. Now, with the two remote controls
(the NEW one requiring code memorisation and the OLD one that is
already memorised), position yourself within the operating range of
the radio controls (within maximum range) and carry out the
instructions listed in the table.
1b
Example
RX
3s
RX
2s
TX
x3
Example
RX
2s
TX
x3
Example
TX x5s TX
1s 1s 1s
TX TX TX
TX x1