During use or while unit is heating or cooling, do not rest appliance on its head. Place
product on its side on a firm, heat resistant, flat surface, as the head will be hot. s the
appliance heats, the housing becomes warm. This is normal.
Steam setting
Set the steam output to the type of fabric to be ironed - see table below.
Tips: Check the fabric's label for recommendations. We recommend that you test acrylic,
nylon or other synthetic fabrics in an inconspicuous area to ensure these fabrics are not
damaged by hot steam. Test fabric for color fastness in an unobtrusive part of the garment
(inner seam). Do not touch silk or velvet with steam head. Some articles can be steamed
better from inside. Heavier fabrics may require repeated steaming. Exercise caution at all
times. For very delicate fabrics, you can remove the brush. To avoid damage to clothes,
keep a distance of 1.5 inches between the steam head and the fabrics. We recommend
that before the first use or after the appliance has been stored for some time to test the
burst of steam.
Steaming clothes
It is normal for a small amount of smoke or steam to be produced the first time the ap-
pliance is used. This will quickly disappear.
Before removing or attaching the fabric brush, unplug your appliance and let it cool down.
• Hang the wrinkled article of clothing on a clothes hanger.
• Pull the clothing taught with one hand.
• Gently press the fabric brush against the clothing and move the
steambrush down the fabric. Keep pressing the burst of steam
button.
• The combination of steam and fabric brush will gently remove the
wrinkles.
• fter treatment, let the garment cool down on the hanger before
wearing.
Do not allow steambrush to run dry.
Type of fabric
Cotton / Linen
Silk / Wool
Synthetics
The steambrush is equipped with a fabric brush.
• To attach the accessory, line it up with the steam head until
it locks into position with an audible click.
• Simply pull on the top of the fabric brush to remove it. You
can operate the unit with or without the accessory.
6
Setting steam
max.
min.