Filling With Water - Rowenta Ultra Steam Manual Del Usuario

Ocultar thumbs Ver también para Ultra Steam:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Filling with water

• Your steam brush has been designed to operate using untreated tap water. If your water is
very hard (check with your local water authority) it is possible to mix tap water with store-
bought distilled or demineralised water in the following proportions:
-
50% untreated tap water,
-
50% distilled or demineralised water.
Warning ! Never use 100%, distilled or demineralised water as this can cause the ap-
pliance to spit and leak.
• Remove the water tank by pushing it back and away from appliance.
• Unplug the rubber stopper.
• Fill the watertank to the top with water and close it securly. Make sure that the rubber stop-
per is properly pushed in place - as shown below.
IMPORT NT: Heat concentrates the elements contained in water during evaporation.
The types of water listed below may contain organic waste, mineral or chemical elements
that can cause spitting, brown staining, or premature wear of the appliance: water from
clothes dryers, scented or softened water, water from refrigerators, batteries, air condi-
tioners, rain water, boiled, filtered or bottled water.
water only as advised above.
Use
• Once the appliance is plugged in, the light will turn on. Set the steam
control dial to the desired setting.
• fter approximately 30 seconds, the light will turn off indicating the
steambrush has reached working temperature.
Be sure to remove lint pad when steaming as excessive water or steam can cause lint
pad color to run.
• Put the tank onto the handle until it snaps in.
• Completely unwind the power cord.
• Plug in your steambrush.
• To begin steaming, press the steam
button with the steamer head facing
away from you, in a vertical position.
5
lso use distilled or demineralised

Publicidad

Tabla de contenido
loading

Tabla de contenido