Buttons For Movements; Function And Description Of The Leds - Nice TTPRO Instrucciones Y Advertencias Para La Instalación Y El Uso

BUTTON FUNCTION DESCRIPTION
TRANSMITTER Enables the functions related to the storage of the
DRY
INSERTION transmitters.
CONT.
COUNTER-
Programmes the counter-clockwise rotation of the
CLOCKWISE
DRY
motor.
CONT.
DIRECTION
CLOCKWISE
Programmes the clockwise rotation of the motor.
DRY
DIRECTION
CONT.
Programmes the behavior of the "dry-contact" in
DRY CONTACT
DRY
the motor.
CONT.
Enables the functions related to the storage of limit
POSITION "0"
AUTO
switch "0".
Enables the functions related to the storage of limit
POSITION "1"
AUTO
switch "1".
Enables the functions related to the storage of
POSITION "I"
AUTO
intermediate position "I".
AUTOMATIC
Starts the automatic search procedure of the limit
SEARCH POSI-
AUTO
switches "0" and "1".
TIONS "0" - "1"
SPEED
Displays and sets the motor speed.
RDC
TIME OF
Displays and sets the duration of the motor's
RDC
MANEUVER
maneuver.
SOFT- START / Displays and sets the level of "soft start" and "soft
RDC
SOFT-STOP
stop".
TORQUE Displays and sets the level of the obstacle sensitiv-
RDC
REDUCTION ity (or the torque reduction).
Displays and sets the level of intervention of the
WIND LEVEL
ON
"wind protection" function.
SWITCHING ON /
Enables and/or disables the automatic movement
SWITCHING OFF
ON
caused by the SUN and RAIN sensors.
SENSORS
RAIN
Displays and sets the direction of movement in
DIRECTION
case of intervention of the RAIN sensor.
Displays and sets the level of intervention of the
SUN LEVEL
ON
"sun protection" function.
Reads the parameters and/or transmitters of the
READ
connected motor and saves them on the internal
RADIO
PARAMETERS
TEST
memory of TTPRO.
Writes the parameters and/or the transmitters of the
WRITE
connected motor, reading them from the TTPRO in-
RADIO
PARAMETERS
TEST
ternal memory.
3 – English
BUTTON FUNCTION
ERASE
RADIO
PARAMETERS
TEST
F1
F1 F2 F3
F2
F1 F2 F3
F3
F2 F3
F1
RADIO TEST
RADIO
TEST
•
Usb
•
Chrg

3.1.1 - BUTTONS FOR MOVEMENTS

A ASCENT: press and release the button
B
MANEUVER STOP: press and release the button
C DESCENT: press and release the button
INTERMEDIATE POSITION (if programmed):
D
press and release the keys

3.2 - Function and description of the LEDs

CONNECTION
DESCRIPTION
LEDS
• LED on permanently:
- no motor connected.
- there have been serious errors of communication and TTPRO did
RED
not recognise the motor properly.
• LED flashes fast: shutdown procedure under way.
• LED flashes slowly: motor search procedure under way.
ORANGE
• LED flashes fast: storing of motor parameters or transmitters
under way.
• LED on permanently: motor connected and properly recognised.
• LED flashes slowly: TTPRO waits for confirmation from the op-
GREEN
erator (pressing of the OK button); after 3 sec the LED stops flashing
and the operation ends unsuccessful.
DESCRIPTION
Deletes the selected parameters; if pressed for 3
seconds, restores the factory parameters.
Auxiliary functions 1 button.
Auxiliary functions 2 button.
Auxiliary functions 3 button.
Displays the RF signal/noise level at 433.92 MHz
Displays the link status.
Displays the battery charge status.
+ simultaneously