Product Description And Intended Use; Electrical Connections; Product Operation; Function And Description Of Buttons - Nice TTPRO Instrucciones Y Advertencias Para La Instalación Y El Uso

1

PRODUCT DESCRIPTION AND INTENDED USE

The TTPRO programmer is a logical unit designed to simplify the installation, testing and
maintenance of Nice motors and control units. It is compatible with motors/control units
of the ERA/ERA INN series.
WARNING! - Any other use different from that described and in ambient condi-
tions different from those provided in this manual is to be considered improper
and prohibited!
TTPRO communicates with the motor/control unit via the TTBUS connection and allows
you to quickly and intuitively perform the procedures normally performed with the trans-
mitter. It acts directly on the motor/control unit, where the transmitters and the operation
parameters are stored.
Other functions are available:
- ability to read the configuration of a motor/control unit (parameters and/or transmitters)
and to transfer the configuration to one or more motors/control units.
- ability to copy and transfer the configuration of a group of motors, if these are connected
to the control panel via TTBUS network.
Components and accessories in the package:
• 1 programmer TTPRO
• 1 connection cable to the motor
• 1 micro-USB connection cable
• 2 rechargeable Ni-MH AA batteries
2

ELECTRICAL CONNECTIONS

WARNING!
- The motor/control unit should only be powered as described in the respective
instruction manual.
- TTPRO must be connected to a single motor/control unit. If you want to connect
multiple motors, it is necessary that each motor is associated with a different
address to those used by other motors. Therefore, before connecting them all,
use TTPRO to assign a unique address to each motor/control unit.
Normally, TTPRO works with 2 rechargeable batteries, however, if necessary, it can also be
powered with the included USB cable.
To connect TTPRO to the motor/control unit, use the cable supplied respecting the polarity
markings (fig. 1):
- white-black cable (COMMON - 0 V) to be connected to the black wire of TTPRO
- white cable (STEP-BY-STEP + TTBUS) to be connected to the white wire of TTPRO
1
3

PRODUCT OPERATION

• Switching On of TTPRO: press and release the ON/OFF button. If it is connected to a
motor/control unit, it immediately displays the functions already programmed and those
available.
• Switching Off of TTPRO: hold the ON/OFF button for a few seconds until it beeps. If
not used, it switches off automatically after 1 minute.

3.1 - Function and description of buttons

BUTTON FUNCTION DESCRIPTION
OK Confirms each programming activity.
OK
Switching on/off of TTPRO and search for con-
ON/OFF
nected motor.
Sending of Open command
OPEN
(= Open button on the transmitter).
Sending of Stop command
STOP
(= Stop button on the transmitter).
Sending of Close command or, for the awnings, De-
CLOSE
scent command (= Close button on the transmitter).
Increase by a single level (bound by the function
+
and displayed by the LEDs).
Decrease by a single level (bound by the function
–
and displayed by the LEDs).
English – 2