Settings/Adjustments; Setting The Type Of "Dry-Contact; Setting The Time Of Duration The Maneuver; Setting The Speed - Nice TTPRO Instrucciones Y Advertencias Para La Instalación Y El Uso

• Deleting position "I"
Press the button
: the LED on the button flashes.
01.
AUTO
Press the button
: the LED on the button flashes.
02.
RADIO
TEST
03.
➔ The green OK LED flashes: (within 3 sec) press the OK button to confirm.
Once this operation terminates, the LED on the button
04.

3.6 - Settings/Adjustments

3.6.1 - SETTING THE TYPE OF "DRY-CONTACT"

Press the button
01. : the current setting appears on the level LEDs.
DRY
CONT.
Use the or button to turn on the LED that corresponds to the desired
02.
setting.
03. ➔ The green OK LED flashes: (within 3 sec) press the OK button to confirm.
Note: the number of Level LEDs
levels available and the
1
types of behaviour of
2
each dry-contact de-
pend on the connected
3
motor (refer to the motor
4
manual).
5
6
7
8

3.6.2 - SETTING THE TIME OF DURATION THE MANEUVER

Warning! - You can set the duration of the maneuver only if limit switches "0" and "1"
have already been set.
Press the button : the current setting will appear on the level LEDs.
01. If the operating time is not programmed, the LED flashes to indicate the closest
approximation, obtained from the motor speed setting.
Use the or button to turn on the LED that corresponds to the desired
02.
setting.
03. ➔ The green OK LED flashes: (within 3 sec) press the OK button to confirm.
7 – English
flashes.
AUTO
Type of dry contact
DRY_1
DRY_2
DRY_3
DRY_4
DRY_5
DRY_6
DRY_7
DRY_8
RDC
Note: the number of Examples of levels available for ERA INN
available levels depends
Level LEDs
on: the type of motor
1
connected, its maximum
and minimum speed 2
values and the positions
3
"0" and "1" stored.
4
5
6
7
8
9 (A1)
10 (A2)
11 (A3)
12 (A4)
13 (A5)
14 (A6)
15 (A7)
16 (A8)

3.6.3 - SETTING THE SPEED

Press the button : the current setting will appear on the level LEDs.
01.
If a speed value has been set with procedure 3.6.2, the LEDs flash to indicate
the approximate closest value.
Use the button or , until to turn on the LED that corresponds to the
02.
desired setting.
03.
➔ The green OK LED flashes: (within 3 sec) press the OK button to confirm.
Note: the number of Examples of levels available for ERA INN
levels available depends
Level LEDs
on the type of motor
1
connected and its ma-
ximum and minimum
2
speed values.
3
4
5
6
7
8
Maneuver time [sec]
5
7
10
15
20
25
30
35
40
50
60
70
80
90
100
110
RDC
Speed (RPM)
6
12
20
26
32
40
48
56