Alarms - Weinmann VENTI motion BiLevel ST WM 24800 Manual De Instrucciones

Malfunction/Error
message
Clock not set
Service indicator
illuminated
If there are any faults which cannot be rectified immediately, contact the manufactu-
rer (Weinmann) or your dealer immediately to have the unit repaired. Do not conti-
nue using the unit to avoid causing greater damage.

8.2 Alarms

A distinction is made between two types of alarm on the VENTImotion:
• low-priority alarms, indicated by the symbol
dow, a
(buzzer).
• medium-priority alarms, indicated by the symbol
alarm window, a
alarm (buzzer).
There are no so-called "high-priority alarms" on the VENTImotion, as this unit may not
be used for life-support ventilation.
Silence alarms
The acoustic alarm of the physiological alarms V
by your doctor (
message appears in the display and the yellow status indicator is continuously on.
Deactivate alarms
If the symbol
IPAP have been deactivated by your doctor.
min
Note
For questions about deactivating/silencing the physiological alarms, please con-
sult your doctor.
Cause
Internal clock of
VENTImotion no set.
yellow status indicator and an acoustic alarm
continuous
flashing
symbol in the status line). In this event, only the relevant alarm
appears in the status line, the physiological alarms V
Press alarm ackknowledgement switch,
clock must be set by your doctor to make
sure therapy is recorded correctly.
Unit must be serviced by Weinmann or a
dealer as soon as possible.
yellow status indicator and an acoustic
and IPAP
Tmin
Rectification
in the alarm win-
in the
can be deactivated
min
T min
Troubleshooting EN
and
35