Set Up Unit; Set Up And Connect Unit - Weinmann VENTI motion BiLevel ST WM 24800 Manual De Instrucciones

4. Set up unit

4.1 Set up and connect unit

Set up the unit on a flat surface, e.g. on a bedside cabinet or on the floor next to the
bed. Keep a space of min. 5 cm between the rear of the unit and the wall, as the
air inlet is on the rear of the unit.
Caution!
Do not cover the unit with blankets etc.. The air inlet would be
blocked and the unit could overheat. This can lead to inadequate
therapy and damage to the unit.
Cable-securing clip
1. Connect the connecting cord to the supply con-
nection of the unit. To do so, lift the cable securing
clip, plug the plug into the supply connection and
clip the cable securing clip over the plug.
Caution!
Always secure the supply plug with the cable se-
curing clip to prevent the plug being pulled out in-
advertently.
2. Connect the connectig cord to a supply socket.
The VENTImotion is designed for a supply voltage
of 115 V ~ to 230 V ~. "Weinmann VENTImotion"
appears in the display.
3. Plug the hose system adapter in the unit outlet.
The unit is now operational.
Set up unit EN 15