25
timer, press the Mode+ button or Mode- button to select an expected
mode.
9 modes can be selected from 1 to 9 and return to
mode 1. d. as followed, set the intensity and the device start to
treat.
Note: different person need different intensity, so you must
increase
the intensity from 0 to 9 slowly and carefully, stop to
increase when you
e. In treating, the 'second' sign in lcd flashes until the time of therapy is
exhausted.
f. after treatment, the device will be shut off automatically.
g. You should hold the plug when pulling it out. please do not pull the wire.
h. please use clear water to wash or use wet cloth (instead of facial tissue)
to gently wipe up the electrodes when cleaning them.
do not use brush or fingernail to do it lest that the surface of the
electrodes should get scratched.
trouBleShootInG
PROBLEM
You have no feeling
of stimulus.
Stimulus is weak.
feel comfortable.
POSSIBLE CAUSE
are the batteries exhausted?
are the batteries properly
loaded?
Is the wire properly connected? Firmly connect the wire.
have you turned off the
transparent protection film over
the electrode pad?
do the electrode pads closely
stick to the skin?
are the electrode pads
overlapped?
are the electrode pads dirty?
Is intensity too weak?
are the electrode pads position
proper?
ENGLISH
SOLUTION
replace the batteries.
correctly load the batteries.
tear off the protection.
closely stick the electrode pad to the
skin.
Separate the electrode pad and
stick them to the skin gain.
please clean the electrode pad.
turn the intensity regulation dial
to regulate it.
change the position of the electrode
pad.