Gima AD-2026 Guía De Uso página 30

the ad-2026 is intended for use in an electromagnetic environment in which
radiated rF disturbances are controlled. the customer or the user of the ad-
2026 can help prevent electromagnetic interference by maintaining a
minimum distance between portable and mobile rF communications
equipment (transmitters) and the ad-2026 as recommended below,
according to the maximum output power of the communications equipment.
Rated maximum
output power
of transmitter
W
0,01
0,1
1
10
100
For transmitters rated at a maximum output power not listed above, the recommended
separation distance d in meters (m) can be determined using the equation applicable to
the frequency of the transmitter, where P is the maximum output power rating of the
transmitter in watts (W) according to the transmitter manufacturer.
Note 1: at 80 Mhz and 800 Mhz, the separation distance for the higher frequency range
applies.
Note 2: these guidelines may not apply in all situations. electromagnetic propagation is
affected by absorption and reflection from structures, objects and people.
Disposal: The product must not be disposed of along with other
domestic waste. The users must dispose of this equipment by
bringing it to a specific recycling point for electric and electronic
equipment. For further information on recycling points contact the
local authorities, the local recycling center or the shop where the
product was purchased. If the equipment is not disposed of
correctly, fines or penalties may be applied in accordance with
the national legislation and regulations.
GIMA WARRANTY CONDITIONS
congratulations for purchasing a GIMa product.this product meets high
qualitative standards both as regards the material and the production. the
warranty is valid for 12 months from the date of supply of GIMa. during the
period of validity of the warranty, GIMa will repair and/or replace free of
charge all the defected parts due to production reasons.
labor costs and personnel traveling expenses and packaging not included. all
components subject to wear are not included in the warranty.
the repair or replacement performed during the warranty period shall not
extend the warranty. the warranty is void in the following cases: repairs
ENGLISH
Separation distance according to frequency of transmitter m
150 kHz to 80 MHz
d = 1.2 √ P
0,12
0,38
1,2
3,8
12
80 MHz to 800 MHz
d = 1.2 √ P
0,12
0,38
1,2
3,8
12
800 MHz to 2,5 GHz
d = 2.3 √ P
0,23
0,73
2,3
7,3
23
30