Care And Maintenance; Back Panel - Sharp UA-PG50E Operación Manual

CARE AND MAINTENANCE

To maintain optimum performance of this air purifi er, please clean the unit including the fi lter
periodically.
Be sure to disconnect the power cord from the wall outlet before performing any maintenance.

BACK PANEL

Back Panel
NOTE How to clean hard to remove dirt
Back Panel
FILTERS
HEPA Filter
Tag
Deodorizing Filter
UNIT
(Pre-fi lter)
Gently remove dust from the back panel by using a
vacuum cleaner attachment or similar tool.
CAUTION
Do not apply excessive pressure, when scrubbing the back
panel.
1. Add a small amount of kitchen detergent to water and soak
for about 10 minutes.
2. Rinse off the kitchen detergent with clean water.
3. Completely dry the fi lter in a well-ventilated area.
Gently remove dust from HEPA Filter and Deodorizing Filter with a
vacuum cleaner attachment or similar tool.
CAUTION
Do not WASH in water and DRY in the sun.
The fi lters are fragile, be careful not to apply too much force.
• HEPA Filter
Apply the maintenance only on the side with the tag.
Do not clean the opposite side; otherwise, the fi lter will be
damaged.
• Deodorizing Filter
The maintenance can be applied to the both sides.
Wipe with a dry, soft cloth
For stubborn stains or dirt, use a soft cloth dampened with warm water.
CAUTION
•Do not use volatile fl uids
Benzine, paint thinner, polishing powder, etc., may damage the surface.
•Do not use detergents
Detergent ingredients may damage the unit.
E-8