AquaScape DIY Waterfall Kit Manual De Instrucciones página 10

STEP 4
PLACE PONDLESS VAULT AND AQUABLOX
• Lay out the AquaBlox
location. The AquaBlox
the wider panel face down. Place the AquaBlox
front edge of the Pondless
• Use a can of brightly colored, highly visible spray paint to
outline the shape around the Pondless
AquaBlox . This will help mark out the area to be excavated.
®
10
®
and the Pondless Vault in desired
®
should be placed side by side with
®
®
Waterfall Vault.
®
Waterfall Vault and
®
STEP 5
EXCAVATE YOUR WATERFALL BASIN
• Remove vault and AquaBlox
approximately 18.5"depth. Once 18.5" depth has been
over the reached, excavate area for vault, an extra 7" down. Please
note an additional 6" of excavation is recommended per
side of the basin to allow for: AquaBlox
sufficient backfill material and compaction required during
backfilling.
25.5"
• Digging can be labor intensive, so pace yourself and
get some friends to help.
• Excess soil can be used to create elevation for the
waterfall and stream or as soil for the berm around the
waterfall.
www.aquascapeinc.com
and begin to excavate
®
®
7"
23"
48"
dimensions,
18.5"